2M Silicone Shower Tray Sealing Strip,Bath Sink Edging Edge Seal Trim,Gap Cover Caulk Strip,Wet Room Threshold Floor Water Barrier Retaining,Bathtub,Countertop Splash Guard(Two Adhesive), White

Very good quality but the adhesive strip doesn't look too trustworthy. I chose to use good quality silicone to stick it in place. So far, so good.

Great quality...however, it refused to go round the corner on our shower tray...it had to be cut, then sealed with a sealant product. It could have had a stronger adhesion too. But, after all of that, it looks very smart and does its job.

Solid silicone. Opted for tape on the one side and silicone sealed the other. looks great, will buy again

Absolutely brilliant sealant its angled and properly fits into the corners old deep bath so had gaps you can turn this to your advantage easy to fit and cut would recommend

Arrived tightly rolled up, after 3 weeks it is still to flatten out enough to use on straight seals, so not used yet. Looks aa though it will do the job, but just how good is the 'waterproof' adhesive?

I ordered this 4M/157inch Shower Strip to seal the gap between my bath and tiled wall. The old silicone sealant had become mouldy and was peeling away, causing leaks whenever the shower was in use. This shower strip has proven to be an excellent solution.Upon arrival, the strip was rolled up in a packet, which initially worried me as I expected a hard plastic material. However, it is a flexible silicone strip, making it highly adaptable and easy to work with. The quality is great and feels durable.Cutting the strip accurately was a bit tricky due to its flexibility. I did a few test cuts using a Stanley knife before making the final cut, and it worked out fine. The adhesive provided, however, is a waste of time in my opinion. It barely holds and is not suitable for creating a water-tight seal. If you’re only sticking the strip for aesthetics, it might work, but for preventing leaks, it’s ineffective.Instead, I stripped away the glue from the strip to make the surface flat and applied a generous amount of waterproof silicone sealant along the edges. Pressing the strip firmly against the bath and tiled wall allowed the sealant to squeeze out slightly, which I wiped away for a clean finish. Once dried, the seal was incredibly strong and completely water-tight. This method creates a much stronger bond compared to the adhesive it comes with.Overall, the quality of this product is excellent, and it provides a perfect solution for sealing gaps in the bathroom. The delivery was fast, and the service was great. Highly recommend this shower strip to anyone facing similar issues.

Easy to install and looked pretty good initially but after a couple of months black mould develops behind the strip as it doesn't actually form a proper seal - it's just decorative.In the end I had to remove it and redo all the sealant around the bath where is had discoloured.It may be OK if you don't have an over the bath shower but I wouldn't recommend it for areas that get really wet.

It’s flexible and easy to cut with a knife or sharp scissors. Adhesive seems ok, but not as good as the standard 3M backing on some products, so I ran a thin bead of silicone along the top and bottom as a precaution. Easy to fit, covering a fairly large (10mm) gap between the shower tray and the wet wall. It’s now been in place for a month, and no issues.